Home → Sparkbooth Questions →

when using two different templates can you have different cut settings?

• Edit

Kristen

22 Jun, 2021 12:54 AM

Hi there,

I am wanting to use 2 different templates for an event this weekend. 1 strip template and 1 postcard.
I usually use the strip template so already have my printer settings to cut the duplicate strips.
I was wondering if there was a setting so I could change the printer settings of a landscape print? so my postcard print doesn't get cut down the middle?
My printer is the DNP DS620

Any advice would be helpful

1. Support Staff 1 Posted by Jorge Oliva on 22 Jun, 2021 01:06 AM

   

   Kristen to be able to help you we need to know whats the email address for this license. no license comes up under this email

   • Edit

2. Support Staff 2 Posted by Joe Connell on 22 Jun, 2021 01:10 AM

   

   You can find your license email in your Settings > About page
   at the top area it will show the email it is registered to.

   RE: printing...
   There is no setting in Sparkbooth to CHANGE your printer settings.
   But, in version 7.0 you can connect 2 printers with one set to cut
   your double strips and the other printer to cut full 4X6 post card style.

   You would need both printers connected and set the Printing
   in Sparkbooth for Printer Setup for Printer Pooling
   (see attached)

   So when you create your Double strip split the software will
   send those prints to the printer you set for CUT and
   the full 4X6 layouts will be sent to the printer for full 4X6

   • PrinterPooling.png 159 KB
   • Edit

3. 3 Posted by Kristen on 22 Jun, 2021 01:27 AM

   

   the email it's registered under is
   [email blocked]

   I only have the one printer, so would you say a solution would be to change the settings to not print and then provide scissors so guests can cut the strip to stick into a scrapbook?
   If so how can this be changed.
   sorry the cut setting was already set up so i've never needed to touch print settings

   • Edit

4. Support Staff 4 Posted by Joe Connell on 22 Jun, 2021 01:36 AM

   

   How are you connected to the owner of the license
   who's email it is registered to?

   • Edit

5. 5 Posted by Kristen Savva on 22 Jun, 2021 01:43 AM

   

   my partner Daniel Davis he was the one who purchased the booth back in February i think it was

   ________________________________

   • Edit

6. Support Staff 6 Posted by Joe Connell on 22 Jun, 2021 01:47 AM

   

   In the past when I didn't have a printer that cuts
   I purchased a small Paper Cutter to cut the 2X6 strips
   from the 4X6 prints... I would suggest you set your printer
   cut full 4X6 and NOT cut 2X6 then manually cut all
   double strips when they are printed.

   The paper cutter was cheap ... about $10 or less

   • Edit

7. John closed this discussion on 04 Jul, 2021 05:27 PM.